The Woodpeckers Coping Sled employs a dual clamping mechanism to secure your work piece preventing the router bit from spinning your work piece. Traps board between adjustable top plate and fence...
You May Also Like
- Traps board between adjustable top plate and fence with slotted top plate
- Easily adjusts for material up to 5-1/2"
- Two clamps move to the center of the work piece to prevent lifting
- Clear guide allows the sled to track along the fence rather than the miter slot
- Includes fully illustrated, detailed instructions
Could have had better
The coping sled was close to what was described but after assembly and use, final product (styles and rails) were distorted. After further looking at the coping sled it was noticed that the bottom plate would bow causing the sled and wood to not sit flat on the router table, even with minimal pressure from the clamping screw. NOTE: WOODPECKER STATED "Extreme hold down force" Not true.. This is totally unacceptable for a pricey item like this. Also, you have to have a fence that is pretty high (5" min) in order for the guide piece to work but Woodpecker did state you may be required to add a sacrificial fence piece. And last, The clamp downs are adjustable in only one direction. If your doing a door that is smaller then 8" or style/rail smaller than 5" then this product will not work.
Love this sled
This sled is really nice! It's well thought out, and is made of quality components. I especially appreciate how it registers against the fence fairly high up, away from the router bit so you don't have to worry about the router chewing into your sled.
Very good product well made