WoodRiver - Round Over Router Bit 1/2"SH 1/8"R
90-day GuaranteeLearn More
Ships for Free
The anti-kickback design of these industrial quality carbide router bits limits stock feed rate for safer router operations. Solid steel bodies are precision machined to carefully controlled...
You May Also Like
Item 828712Model 34-124
Item 127284Model 1580
Item 828713Model 34-126
- For uniformly rounded edges
- Lowering the depth setting will produce a rounded corner with a decorative fillet
- Changing the guide bearing to the 3/8" bearing converts round over bits to beading bits
- Shank: 1/2"
- Radius: 1/8"
- Diameter: 3/4"
- Cut Length: 3/8"
- Overall Length: 2-3/8"
Great ! Cuts like a bit should
Used it on oak finish was great !
For [$] I expected a pretty good bit. This bit is absolutely horrible, the bearing is slightly undersized by a hair so the bit always leaves a tiny groove on the routed piece. When I was doing production work, I had to spend an extra few hours to sand the groove out. I ended up putting a slight piece of tape around the bearing so the groove wasn't so deep. These bits are horrible, stick with Whiteside or CMT. I wish I could ask for a refund, but this bit is just going into the garbage.
wood river round over bit
cutter seems ok but the shank is far too short for bigger routers