Pinnacle - Matched Chip Breaker and Blade for WoodRiver and Lie-Nielsen Handplanes #4 1/2,#5 1/2,#6 and #7
90-day GuaranteeLearn More
Ships for Free
Pinnacle Matched Chip Breaker & Blade Sets for Lie-Nielsen Bench Planes Performance begins with the blade. IBC blades are the best kept secret in the industry and as they continue their quest...
You May Also Like
Item 150893Model RBMS-0384
Item 150063Model RBBE-0340
Item 150894Model RBMS-0385
Item 150813Model RBMS-0395
Performance begins with the blade. IBC blades are the best kept secret in the industry and as they continue their quest for perfection, they realized that better blades deserved a better chipbreaker. The innovation starts with design and materials: O-1 Steel is hardened to 30-32HRc then precision machined and sharpened to provide a durable, perfectly-mating edge that fully supports the blade. This greatly reduces vibration and chatter which leads to a finer, consistent shaving. Each chipbreaker is matched - ground and serialized to its blade at the time manufacture for a perfect match. The sides are precision ground and hand polished to a beautiful finish. Made in Canada.
- Razor Sharp – “Out Of The Box”
- A-2 Tool Steel, Double Tempered To 60-62 HRc
- Fully Stress Relieved and Air Hardened
- Cryogenically Treated
- Fully Demagnetized
- Precision Ground Top/Bottom
- Precision Ground/Hand Polished Sides
- Ships with Micro-Thin, Water Soluble Rust Inhibitor
- O-1 Steel
- Hardened to 30-32HRc
- Precision machined and sharpened mating edge
- Precision Matched - Ground and Serialized to each Blade
- Revolutionary Blade Adjuster Tabs
- Precision ground polished edges
- Flat to 0.0005” across leading edge
David Charlesworth says, "The Pinnacle matched blade/breaker is the best prepared that I have seen. The chipbreaker is outstanding and a few strokes on each surface will perfect it. Blade flatness and finish are excellent so the total preparation time is minimal. With proper tuning and sole flattening results should be comparable to premium modern planes. The benefit of this set is the reduced preparation time and the ability to fit a thick blade to a Stanley. This option has not been available before.
I have been tuning up old Stanley planes for over 30 years. We have even salvaged planes from before 1910. Tremendous satisfaction can be had from reviving and using an old heirloom."
a lot of good steel
Replacement blade for old plane. Works better than the original.