The critically acclaimed precision Microjig® GRR-Ripper 3D Pushblock System will forever change operating a table saw. You will gain the confidence needed to comfortably make ultra-thin cuts with surgical precision and the control needed to make the exact cut that you want. No other pushblock offers this level of precision, control, and safety. The GRR-RIPPER was built for the table saw allowing you to safely cut stock down to ¼” x ¼”. However, the GRR-RIPPER's uses around the workshop are endless. The GR-100's powerful grip controls stock and protects your hands from dangerous spinning bits on the router table, provides the traction needed to properly flatten stock for face-jointing on the jointer, and applies even pressure against the fence on your bandsaw lessening blade drift and resulting in smoother cuts. Kickback occurs when the workpiece strays from the fence, and gets pinched between the saw blade and the fence. The rear teeth of the blade grab the workpiece, turning it into a dangerous projectile. The only way to avoid kickback is to maintain control of your workpiece through the entire cut. The GRR-RIPPER provides downward and inward pressure, keeping both sides of the cut parallel to the blade. This prevents the workpiece from straying from the rip fence, virtually eliminating kickback.
