Q: I’ve seen conflicting advice regarding how to orient the annular rings on boards when edge-gluing them to make up wide panels. Should I alternate the direction of the rings or keep them all oriented the same way?
Kirby Hastings
Kansas City, MO
A: This debate goes back to the days when woodworkers had wider, but inconsistently dried stock to work with. Flat-sawn boards tend to cup opposite the orientation of their annular growth rings. So if all the rings of the boards that make up a panel are oriented in the same direction, the panel will tend to curl like a potato chip as it adjusts to its environment. This tendency can be overcome by fastening the panel to an apron, adding breadboard ends, or trapping it within a frame.
If the rings in the boards are alternated, the panel will tend to develop waves, or ripples across its surface. But overall, the panel will remain flatter. I take this approach when making unsupported panels such as table leaves, using riftsawn or quartersawn stock if possible for best stability.
For panels that will be supported in some manner, I simply arrange the boards for the best face grain match, and ignore the annular ring orientation.
Ken Burton
Senior Editor,
Woodcraft Magazine
