View a Larger Image of Guide Rail Connector 1 per Pack - 2 Recommended
Item 482107
Model 482107

Festool - Guide Rail Connector 1 per Pack - 2 Recommended


Woodcraft is the Nation’s Largest Full-Line Dealer of Festool Tools & Accessories!

Compare With


Use to connect two guide rails for long workpieces. FS/2 guide rails require 2 connectors. These are sold as each.

  • Hard-anodized surface
  • Soft, non-slip coating
  • Hard rubber splinter guard
  • Mounting slot for: FSW angle unit, 2 FSV connectors, FSZ clamps, FS-AW Deflector
  • Festool products can only be sold in the 50 states


3.5 out of 5 stars
2 Reviews
  1. 3.0 out of 5 stars
    by on

    You need to buy TWO (2)!

    As my title says, if you are going to use these to join two guide rails for the TS-55 or TS-75 you will need to purchase two. Why they don't come in a two-pack is beyond me. Plus, I think they are a bit pricey for a straight hunk of metal with four set screws, but that's Festool. Also, the set screws have shallow slots. After 4 or 5 uses the slots are already worn from the screw driver slipping. I will be looking for Allen wrench (hex hole) set screws to replace them. Other than that they do what they're supposed to. I recommend it if you need it. I have a 55" track and a 42" track. Joined that gives me a 97" track for cutting down the length of sheet goods, but with no run-on or run-off for the saw, which makes cutting the ends awkward and potentially sloppy. Two 55" rails joined would be better. But I may eventually pop for a 106" rail.

  2. 4.0 out of 5 stars
    by on

    Great product,

    HOWEVER - Some Guide rails can be difficult to align properly. Check that the ends are machined to exactly 90 deg.

Top of Page