View a Larger Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
View a Larger Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
View a Larger Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
View a Larger Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
View a Larger Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
View a Larger Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
  • View a Different Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
  • View a Different Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
  • View a Different Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
  • View a Different Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
  • View a Different Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")
  • View a Different Image of Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")

Kutzall

Extreme Cylinder Burr, 1/8" Shaft, Very Coarse (1/4" x 1/2")

Item 162998
Model CX-14-EC

$21.99

When you need to remove material in hurry but still require precise control, there are no better tools for the job than Kutzall Extreme Burrs. The 1/8"-shaft Extreme Cylinder Burrs come equipped with a rugged, very coarse coating applied by fellow craftsmen. The aggressive, razor-sharp,...

Details

When you need to remove material in hurry but still require precise control, there are no better tools for the job than Kutzall Extreme Burrs. The 1/8"-shaft Extreme Cylinder Burrs come equipped with a rugged, very coarse coating applied by fellow craftsmen. The aggressive, razor-sharp, tungsten-carbide teeth hog material away with unparalleled efficiency, while also resisting loading. This lets you spend more time carving and less time clearing your tool. Kutzall burrs are handmade in America (the Motor City suburbs, to be exact!).
Note: Diameter and head length dimensions on Kutzall burrs are base dimensions. The coatings add approximately .060" - .160".
  • Cut flat areas or round over edges
  • Produce 90-degree corners
  • Tilt to make V-cuts
  • Cut on both the OD and the end of the tool
  • Head diameter: 1/4" x 1/2"
  • Grit: very coarse

Compare With

Top of Page