Whiteside - 6002 2 Pc Ogee Stile And Rail Door Router Bit Set 1-5/8" OD x 7/8" CL 1/2" SH
$128.29
Make full size Stile and Rail joints on your router table. The interlocking design plus the raised panel groove are both cut in one pass. Ball bearing guides control the cutting depth and also...
Items You May Need
-
Item 146201Model 5920C
Whiteside - 5920C 2-Wing Large Raised Panel Router Bit 3-1/4" D with Back Cutter, Ogee Cove
$128.29
Compare With
-
Item 814981Model 6005
Whiteside - 6005 2 Pc Traditional Stile And Rail Door Router Bit Set 1-5/8" OD x 7/8" CL 1/2" SH
$128.29
-
Item 150805Model 6003
Whiteside - 6003 2 Pc Bead Stile And Rail Door Router Bit Set 1-5/8" OD x 7/8" CL 1/2" SH
$128.29
-
Item 150683Model 94-150
Freud - 94-150 Adjustable Rail And Stile 5-Pc Door Router Bit Set Ogee Panel Round Rail 1/2" Shank
$269.47
-
Item 150693Model 97-276
Freud - 97-276 Adjustable Rail And Stile 3-Pc Door Router Bit Set Ogee Panel Ogee Rail 1/2" Shank
$183.47
-
Item 813830Model 6006
Whiteside - 6006 2 Pc Classical Stile And Rail Door Router Bit Set 1-5/8" OD x 7/8" CL 1/2" SH
$128.29
-
Item 820246Model 6004
Whiteside - 6004 2 Pc Straight Stile And Rail Door Router Bit Set 1-5/8" OD x 7/8" CL 1/2" SH
$128.29
-
Item 150686Model 97-154
Freud - 97-154 Adjustable Rail And Stile 3-Pc Door Router Bit Set Ogee Panel Round Rail 1/2" Shank
$183.47
-
Item 150691Model 97-254
Freud - 97-254 Adjustable Rail And Stile 3-Pc Door Router Bit Set Ogee Panel Ogee Rail 1/2" Shank
$183.47
-
-
Item 150690Model 97-252
Freud - 97-252 Adjustable Rail And Stile 3-Pc Door Router Bit Set Cove Panel Ogee Rail 1/2" Shank
$183.47
Details
With these 2-piece sets, simply switch router bits to change from cutting stile to cutting rails. Ideal for stock from 5/8" to 7/8" thick. Carbide tipped router bits, all are 1/2" shank.
Construction Tip: You can make Stile & Rail cuts for glass doors using Whiteside's Door Construction Sets. No extra components are required. All that's needed is to stagger the cutting edges and "stack" both groovers on the Stile bit. Use both bearings (no groover) on the Rail bit. Make your cuts just like in normal door construction. Cut the inside edges of all four pieces with the Stile bit. Trim the ends of the Rails with the Rail bit. Assemble door and insert glass pane. Use clips or corner trim mold on the back side to hold the pane in place.D = Diameter; CL = Cutting Length; RW= Reveal Width; SH = Shank Diameter; OL = Overall Length.