Slick Strips, 3" Width
Slick Strips reduce friction to the point where almost everything moves like it's mounted on ball bearings! This special UHMW (Ultra High Molecular Weight) adhesive-backed flexible plastic film has...
You May Also Like
- Nominal 3" Width, 1/32" Thick
- 10ft rolls
- Easily cut to length
great product--works like a charm
Made my table-saw fence better when it was already good!
I'm using on the surface of my snow shovel. There are shovels online made entirely from it, but too expensive. I've build my own.
Very easy cut and trim. Super slippery.
The fence on my table saw was not true so I removed the old cover and replaced it with a 3/8" x 2-1/2" aluminum bar. I used slick strips on the face of the aluminum and found it easy to trim with a sharp knife. Now my fence is true and very slick.
Did just what I needed it to do.
Built an ajustable assembly table and used the Slick Strip to help parts slide past each other.
band saw table and fence
No other product like it!
Whenever I make drawers, I place strips on the bottoms of each of the drawer sides. It makes for effortless drawer operation. I used the product for the first time about fifteen years ago (on the drawers of a five-drawer dresser) and the adhesive is still adhering the material to the bottoms of the drawer sides.
Exactly what we needed
we use this product on precision slide mechanisms in our pipe organ consoles - easy to use - also for machinery guides and homemade jigs
Slick Strips for drawers
I used the slick strips to provide a smooth surface for drawers in a bow front chest, Cut the strips into 1.5" strips and simply stuck in place. Helps in moving the drawers.
Slick, Slick Strips
Used to increase drawer-sliding ease for boxed-in drawers. Very easy to use and apply. Not sure about adheasive: after misapplying one section, it was just TOO EASY to lift off, and that was after rolling it down with a laminate roller! Time will tell.
I'd buy this product again.
I purchased this product for use as a skid plate on the belly of a model airplane. It is heavier than I would like, but works well. I will use the remainder of it on the fences of all my shop tools...it's intended purpose!
Just what I needed.
just sliding along
Great self adhesion and used wherever you need excellent sliding properties between surfaces.
Does the job
I applied pieces of "slick strips" to the bottom of dinette chairs to protect the floor and to allow the chairs to slide easily over the floor. Slick strips worked much better than felt pads.
Great for table saws or router tables!
I installed Slick Strips on both my table saw and router table fences. I am amazed at how much less drag there is as I use these tools. I would recommend Slick Strips to anyone who wants to enhance the performance of their table saw or router table.
It appears to be exactly what I need.
I haven't used it yet but I know it will provide the slick surface I need for the Woodmaster Sander table.
Great product, hard to find
Very helpful on saw table fences and other contact areas that need frictionless surfaces.
Used on miter jigs on router table and table saw.
Great for miter slots. Also used it on router base.