If you own a miter gauge – any miter gauge – you can turn it into a performance boosting miter sled in just a few seconds by simply docking it in place on top of this unique sled. This sled is a...
You May Also Like
Note: Miter gauge shown in photo available separately.
- Miter gauge not included
- Doubles any miter gauge's crosscut capacity to 24"
- Provides zero clearance for safe and accurate cutting
- "Dock and Lock" any Miter Gauge in seconds
Typical Incra accuracy and reliability, it has taken my cross cut accuracy a step up.
Typical Incra precision, it lifted my cross cutting to a new level, consistent 90 degree cuts.
Perfect accessory for my table saw
I needed a sled for my contractor grade table saw. Since they are much smaller than a full size saw, I needed a smaller sled. I didn't want to spend a lot of time making one from scratch and have it end up probably not accurate, so I did my homework. There was only 1 obvious choice. the Incra Miter Express. It was small yet was customizable to fit my saw to a tee. All parts were clearly marked and the instructions were clear and accurate. Slides great and doubles as a zero clearance insert. Worked just like the Videos said it would. Today I attached the Incra 1000HD miter gauge and these two will probably never be separated again. This is without a doubt the best add-on to my saw I could ever hope to do. Thanks Woodcraft for having it in stock. You guys are going to make a pro out of me yet.