View a Larger Image of Chuck Reversing Adapter 1-1/4" x 8 TPI x #2 Morse Taper
Hold Fast A874
Item 149370

Chuck Reversing Adapter 1-1/4" x 8 TPI x #2 Morse Taper

$34.99

(3) Reviews Write a Review
In Stock check in-store availability

This chuck reversing adapter features a #2MT on one end to fit into your tailstock and threaded on the opposite end to screw into your chuck. Unscrew your chuck off the lathe headstock without...

More Details
Articles & Blogs Videos

You May Also Like

Details

This chuck reversing adapter features a #2MT on one end to fit into your tailstock and threaded on the opposite end to screw into your chuck. Unscrew your chuck off the lathe headstock without removing your bowl, screw the reversing adapter into the chuck and install the bowl-chuck-adapter into your tailstock. By sliding the tailstock up the bed until the bowl touches the vacuum head you can perfectly center your bowl on the vacuum head to finish turning perfectly centered.



  • #2 Morse taper
  • 1-1/4" x 8 TPI
  • Designed for use with Hold Fast vacuum chucking system

Videos

Articles & Blogs

Psp1

Helping a woodturner quickly mount turned work on the lathe without having to form a tenon and leave chuck marks sums up the function of a vacuum chuck. In the case of the Hold Fast Vacuum Chuck Turning System, you can choose from a 3" or 6" vacuum head.

Read More >

Reviews

3 Reviews
Write a Review
  1. by on

    VERY HANDY FOR VACUUM CHUCKING

    Will use almost exclusively for transfer from 4 jaw chuck to vacuum chucks for bowl turning

  2. by on

    Reversing Adapter

    I have only had it a short time and used it several times already. It is great to center bowls and platers etc. on a vacuum chuck for removal and finish of base. Great tool and a time saver for any turner that uses a jam chuck or vacuum chuck.

  3. by on

    A must have tool

    This tool is important when you flip a piece around for your vacuum chuck to finish the bottom. You simply leave it on the chuck, put it in the tail stock and gently push it up until the vacuum chuck takes over. Then the piece runs true when you finish the bottom.