How to Make a Longworth Chuck with Ron ThompsonComments (0)
Woodworking Adventures is back with a new blog site and our first story is in the shop with the“Turning Tuesdays” guys with another home spun turning project. Ron Thompson shows us how to make a self-centering Longworth Chuck. The Longworth chuck was developed by Leslie Douglas Longworth of the Hunter Valley Woodturners in Australia in the late 1980′s. Featuring a self centering mechanism that easily and quickly adjusts to the size of your turning by using a pair of disks which rotate against each other, drawing in and out the attached rubber jaws on a series of opposing arcs.
In this build, a holding fixture is made to fit the 1″-8 diameter faceplate.
The fixture is clamped to the workbench using Bessey 6″ F-style clamps. The faceplate and chuck assembly are clamped to the fixture located by the faceplate hole.
Circles of 1″ and 2″ diameters are marked from the center of the chuck, followed by a circle drawn 3/4″ in from the outside edge. Another circle is drawn in between that circle and the 2″ circle. In this case 6 arcs of 4-3/4″ for the slots are drawn with a compass as shown below.
In addition thumb holes are machined through for opening and closing the chuck with a 1″ forstner bit.
Sand the rough edges and add finish if desired.
Complete build details are in the video:
This exercise was making a 6-slotted Longworth Chuck. To make an 8-slotted Longworth Chuck, follow the instructions on this link.
More sawdust will be flying from Codger Lodge with another “Turning Tuesdays” episode on “How-To” build your own Spin-A-Way Tail Stock, so stay linked. We hope you like our new blog site design, so let us know what you think and tell your woodworking friends all about it…
Item 08L42Model 5003
Item 125927Model 125927W
Item 146980Model GSCC2.506
Item 43A23Model DW625
Item 50D01Model CBUPC1436
Item 818489Model UD2100
You must be logged in to write a comment. Log In