View a Larger Image of 16" Dual Handle Push Block
WoodRiver PB12
Item 111171

16" Dual Handle Push Block

$12.50

In Stock

Qty 1-1 2+
Each $12.50 $11.25

16" Push Block provides positive two hand control for medium length (10" to 20") stock.Safety16"Anti-slip bottomsIdeal for use with a table saw, router table, or jointer

You May Also Like

Details

16" Push Block provides positive two hand control for medium length (10" to 20") stock.Safety

  • 16"
  • Anti-slip bottoms
  • Ideal for use with a table saw, router table, or jointer

Articles & Blogs

Forrestblades

The newest blade from Forrest Manufacturing is the 10″ Ply Veneer Worker with 70 Teeth, and is specifically designed to work with man-made materials in the plywood, vinyl clad, composite and veneer arena. Each tip is made from super hard, long life micro-grain carbide, and the ATB (35° Alternate Top Bevel) produces the smoothest cut ever seen in a hand-straightened saw blade. The 10° face hook allows for easier feed on table saws, and sides are chamfered to eliminate heat buildup and chip clearing. This thin (3/32″) kerf blade is 10″ in diameter and has a 5/8″ arbor. This blade is also available in standard (1/8″) kerf. For use on table saws and saws with slides. Made in the USA.

Read More >

Reviews

5.0 out of 5 stars
1 Review
  1. 5.0 out of 5 stars
    by on

    Don't underestimate, this is very useful

    I actually purchased this tool with the intent to use it as a "long-board" for sanding and faring a wooden boat. I didn't expect much as it looked cheap (orange plastic) and was fairly in-expensive. It has turned out to be a great tool and quite durable. I have used it for 1 year and the plastic and rubber show no signs of failure. The width is a perfect 2.75" thereby taking a 1/4 section of a standard sanding sheet. I use 3M spray adhesive to fix the sheets (use two strips and spray only the paper) and remove the used paper with a heat gun. There is only slight waste as about 1 1/2 inches of paper is cut off of one end. This works great for flat and convex surfaces as there is just the right amount of flex in the body to conform. It can be used to push stock through planer/saw but I wouldn't trust it to handle a difficult feed as I prefer a rigid hook to keep from slipping. Great tool and great value. Even with the boat done I would replace this immediately (if lost) as it has so many uses.

Top of Page