$36.99
LEECRAFT Phenolic Inserts and Sheet Stock reduce splintering and chip-out on the bottom side of regular or dado table saw cuts. Simply raise your saw blade through the insert to create a "kerf" which precisely matches the blade on your saw. These 1/2" thick inserts are precision...
Details
- Delta
- Frictionless
- High density phenolic laminate
- 13 3/8" X 3 3/4"
Articles & Blogs
Leecraft Zero Clearance Insert Product Guide
Find the proper insert to fit your model tool.
Reviews
-
Did Not Fit
The Leecraft insert DOES NOT fit on the Delta 36-725T2 that Lowe's sells.
-
question
As someone's already asked, does this fit the 36-725 Table Saw sold by Lowes? The Delta website doesn't even recognize that brand, and most parts for Delta contractor saws don't fit this model.
-
Does this fit delta 36-725?
Curious if this fits the model sold at lowes
-
easy setup
can't say enough about these throut boards
-
Perfect fit
Perfect fit for my Craftsman Table saw Model 221240.
-
Good Product
This is a quality product and I would recommend it to anyone. It fit the table very well and leveled up real easy with the adjustment screws.
-
Great Product
Performs exactly as advertized. Fits very well. Snug fore and aft, side-to-side, and level with table. Perfect!
-
Great Insert
The best thing I thought was there is an adjustment screw to remove any slop both forward and sideways making the insert very snug. Also has 4 leveling screws. All these adjustment screws are already installed so all you have to do is raise the saw up through the plate. I will order them again when needed.
-
EXCELLENT REPLACEMENT - EASY TO USE
Excellent replacement
-
ZCI works fine with woodcraft support is
This ZCI works fine now. I called woodcraft to request a ZCI for my grizzly g1023 saw and this is the model I was given. Even after double checking with them that the grizzly wasn't listed as compatible I was assured it would fit. When I called woodcraft support all they offered was that it should fit with out modification and that I could probably return it if I wanted. I opted to break out a belt sander and take about 1/16" off all around to make it fit. Now it seems fine.
-
[...]
I currently use my table saw in making cabinet boxes. I need to change blades and set ups. I know I could have made my own zero clearance however, I find it to be time consuming and occassionaly frustrating to get proper thinkness. I have fabricated my own zero clearance insert for use with my dadoe saw.
-
tight fitting insert
The adjustment screws for the height, width and length of this insert make it very tight fitting. Also the weight of the phenolic eliminate any rattling around. I've bought several different brands of UMHW plates but none of them come even close to these phenolic ones
-
Custom adjustment required
Used in an older model Delta Contractors saw. Once adjusted it fits great and does what it should. To make it work in my saw I had to expand the pre-grooved slots on the underside of the zero clearance insert so the 10" saw blade would clear during set up and initial start up. I used a burring tool in my Dremmel tool to do the job. Once making the appropriate groove deeper the rest of the set up was easy.
-
Works great fits great
Works great , should package it in 2+ , most of us that use ZCIs need them for cross, rip & dado cuts, still a grear product
-
" I need more than one"
Should come in a package of two(2) or more. Because you need more than than one.
-
I would buy this product again
fits my saw perfect
-
Excellent
Works great.
-
Good additon to any table saw
Good instructions and works well to reduce tearout. Stays put and easy to adjust
Compare With
-
As Low As $33.29
$36.99
