Tips & Tricks: Restoring Aluminum Tables

Comments (0)

This article is from Issue 107 of Woodcraft Magazine.

If you should happen to cut a little too deep on your CNC machine and scar the aluminum table, don’t despair. Most of these tables are made up of narrow, two-sided extrusions. To hide the damage, loosen the holding bolts and flip the extrusion over before retightening everything. Then double-check your cutting files before it happens again.

—Bob Berner, Allentown, PA

0 Comments

Write Comment

Write Comment

You must be logged in to write a comment. Log In

Top of Page