Tips & Tricks: Perfectly Perpendicular Holes

Comments (0)

This article is from Issue 107 of Woodcraft Magazine.


Drilling a hole that is exactly perpendicular to a surface is easy enough if you can fit your workpiece on a drill press. But keeping your handheld drill at a perfect 90° is challenging, especially when working toward the center of a wide surface. To help with this, I made a drilling guide by clamping a steel spacer in a handscrew with a V-notch sawn into one of its jaws. To make your own, cut the notch at the table saw and use the reassembled handscrew to hold a spacer whose inner diameter just accommodates your drill bit. My local hardware store carries these spacers in 2" lengths with inside diameters ranging from 1/16–1/2".

—Richard Entwistle, Highland Lakes, NJ

0 Comments

Write Comment

Write Comment

You must be logged in to write a comment. Log In

Top of Page