Tips & Tricks Issue 82: Magnetic Drill Press Key

Comments (0)

This article is from Issue 82 of Woodcraft Magazine.

I recently read a drill press review where the writer complained that there was no place on the machine to store the chuck key. If you have a similar situation, do what I did when I got my drill press: I epoxied a rare-earth magnet to the rear end of my chuck key. That way, I can always find it attached to the underside of the cast iron table or other dedicated location. I don’t even have to take my eye off the work to grab it or put it back.

—Richard Lewis, Port St. Lucie, Florida   

Related Products


Write Comment

Write Comment

You must be logged in to write a comment. Log In

Top of Page