Simple Featherboard for a Table Saw
Comments (0)
Use
a 1 inch strip of 3/16 polycarbonate as a featherboard to hold material in
place while ripping on the table saw. The polycarbonate plastic is simply held
in place against the miter gauge with a C-clamp. On my Ryobi BT 3000, it is
extra simple because the miter gauge can be moved across as the board gets
narrower; however the concept will work on regular miter gauges too!
Bar Clamps
Write Comment
You must be logged in to write a comment. Log In
0 Comments