Rotating Carver's Easel

Comments (0)

This article is from Issue 49 of Woodcraft Magazine.

Rotating Carver's Easle

When I’m relief-carving panels, I prefer to work at an easel, which reduces the amount this old back has to bend. While working on an intricate design recently, I found myself constantly reorienting the panel to allow carving with the grain. To make the job easier, I screwed a rotating platform to the easel, attaching the carved panel to the platform by wedging it between cleats, as shown. 

Now I can simply rotate the platform and workpiece as necessary to gain the best angle of attack.

I find that the single pivot screw creates enough friction between the unfinished easel top and platform to stabilize the platform. However, if I find it shifting under tool pressure, I’ll drive an additional locking screw through its corner.

Philip Houck, Boston, Massachusetts

0 Comments

Write Comment

Write Comment

You must be logged in to write a comment. Log In

Top of Page