GRR-RIPPER Advanced by MICROJIGComments (0)
This is the first tool that grips and holds both sides of work piece during a ripping operation. Unlike a push stick or push block, the Gripper maintains balanced pressure on a work piece as it passes through and beyond the blade. Maintains a parallel, forward direction with the blade while keeping pressure against your rip fence to prevent burning. Eliminates the need to feed stock with your bare hands providing 100% protection. You can cut strips as thin as 1/4" without any special setup so there is no need to throw away those small scrap pieces. The unit can be offset to accommodate small, irregular shaped, pieces on the router table.
The GR-200 model boasts all of the same innovative features of the GR-100, but it comes with two additional accessories the Adjustable Spacer and the Stabilizing Plate. Combined these accessories improve the control and expandability of the GRR-Ripper System. The Adjustable Spacer adds increased gripping surface for tackling larger stock. It also adds one inch of cutting width to the GRR-Ripper and acts as a secondary balance support for small stock and straight-line ripping. The Stabilizing Plate improves control of the GRR-Ripper when cutting small narrow pieces of stock. Perfect for trickier cuts like resawing, bevel edging, pattern routing, and much more. The Stabilizing Plate also acts as a secondary fence that travels with the GRR-Ripper along the left side of the stock. It holds the off-cut piece in its original position through the entire cutting operation.
You must be logged in to write a comment. Log In