Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 1
Back to top
Changing chuck jaws is a joy
nr. Ithaca, NY
Easy Wood Tools 4 Jaw Easy Chuck 1-1/4" x 8 TPI w/ Double Ended Easy Chucking Screw
The video is right, changing chuck jaws is a joy.
Just push in the included release allen key and each jaw easily pops out. No need to worry about numbers and 4 or 8 screws when attaching the new jaws. Not to mention the frantic searching when you drop a screw!
The T handle allen wrench allows one to really crank down on the tenon for a large bowl. Crank, rotate 180 degrees to the 2nd spot, crank - repeat until really tight.
If you do just "normal" turning where you only need the #2 or 50mm jaw then you probably don't need this chuck.
If you do any turning where you need to change jaw sizes then this chuck is a no brain. The ease of, and short time required, to change chuck jaws will quickly pay for the chuck: in sizing the tenon or dovetail to the work - instead of to the jaw you have installed; time & labor savings; and increased productivity.
I use a Kelton coring system. So I can start with a large tenon and the large jaws then quickly switch to the smaller jaw sizes for smaller tenons as the bowl sizes go down.
If I make a tenon too small then switching out jaws is only a few seconds not minutes.
Or if I made the dovetail on the bowl face for a larger jaw then it takes only a few seconds to switch back to the larger jaw. So I can now chuck the larger dovetail in the bowl face to turn the tenon on the just extracted blank.
I did have to create my own size chart for the various jaws so I know what size to make a tenon or dovetail.
Yes, I would recommend this to a friend
1 - 1
Back to top
©2014 by Woodcraft Supply LLC