$500 Off NOVA 1624-44 Lathe
Whatever projects you turn, the Nova 1624-44 wood lathe will meet your needs for a lifetime.
Buy Now $899.99
Go Mobile w/Heavy-Duty Casters
Save 30% on Heavy-Duty Casters through April 25.
Shop Sizes & Styles
Buy Laguna 14-12 Bandsaw & Get a Free Industrial Flood Light
Perfect for serious woodworkers and hobbyists.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 2
Back to top
Update to My Previous Review
Maple 7/8" x 250' Edge Banding
This is an update to my earlier review. I finished my cabinetry project, including dye, finish and installation. Several weeks later I noticed the edge banding had begun to lift in a couple of places -- it is fairly obvious because I used a semi-gloss finish. I don't know whether it was a particular roll. All seemed fine when I ironed it on and subsequently finished it. The water-based dye and finish may have affected the bond, though it shouldn't have given that the glue is non-water soluble (basically pre-applied hot melt glue). I plan to try to re-iron it using a test piece to make sure the heat from the iron will not damage the finish. An alternative is to inject a little yellow glue into the seam and to tape it down to dry. I'll report back on results. Still, given ease of installation and good results nearly everywhere else, I would recommend this product, but with caution, and not for high-end projects.
Yes, I would recommend this to a friend
I don't expect much from most "time saver" products, but the thought of cutting an applying hundreds of feet of solid maple strips to finish the plywood edges of some kitchen cabinets compelled me to try this product.
First, it arrived well-packaged, in one continuous roll of very uniform material. The material looks good. The joints are not noticable. I had to look for them. The glue is evenly applied on the back side. The material did not stick to itself as it came off the roll.
I applied it using an ordinary teflon-coated household clothes iron with no water in it, set on high. The glue melted easily. I found that the material did curl a little behind the iron, so I either held the freshly-glued part against the cast iron surface of my table saw to cool it or held an iron carpenter's level against it. Tapping on the edge with fingertips reveals any hollow spots. If it does delaminate, the glue re-melts easily and re-adheres.
A skew low-angle block plane worked best to trim away the excess (skew angled inward). You can tell when you are almost to the plywood surface because the excess glue squeeze-out will begin to roll up beneath the plane. At that point, I switched to a random orbit sander with 100 grit paper, which trimmed it flush in one pass.
The excess glue will stick to the bottom of the plane but it comes right off with a little mineral spirits.
The glue line is minimal, allowing you easily to see if there are any "wide spots" that could be pressed a little tighter with another pass of the iron.
All in all, this stuff works. My neighbor, who also is a woodworker, thought I had built my cabinets from solid wood until I showed him the edgebanding. So now you have two loyal customers!
1 - 2
Back to top
©2014 by Woodcraft Supply LLC