New Festool TS 55 REQ Plunge Cut Saw
Festool has made the best plunge saw better.
JET Benchtop Spindle Sander
Save $100 on this customer favorite!
Save $50 on HTC-3000 Mobile Base
Fully adjustable, holds up to 700 lbs.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Order now for current pricing.Item will ship after 05/24/2013
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 6
Back to top
Comes out sweet
Tool Maker Mike
East Tawakoni, TX
Pen Inlay Kit - Red Rose - for Wall Street II and III
My inlay went together with difficulty. Took a lot of pressure to properly seat the components.
Yes, I would recommend this to a friend
Be very careful.
Canyon Country, CA
Be sure to flood the design with CA and always "turn down" with sandpaper only. I tried to start a little with tools, the rose caught and blew out into unfindable pieces. I will try it again, but this time, no tools.
Once finished, looks fantastic
When assembling, the red rose portion broke into several pieces that had to invidiually be inserted into the form. Once completed, turned and finished, the end product looked great!
Not for a beginner
Rich the turnarounder
I've put together about 20 inlay pens from different places. After they are initially laser cut, the pieces will tend to twist and warp. You will need to take your time putting them together. Sometimes you will need to use sandpaper, sometimes a little force, sometimes even breaking a piece. I usually save a little dust when sanding in case I need to fix something that chips. Always sand the piece smooth before putting a tool to it. If not, don't be surprised if a piece chips out and gets sucked into your dust collector.
West Bloomfield, MI
Was the first time making a pen. The parts were a little hard to place, was concerned that they would break easily, not the case. Turned out great for a first time project. Used Wall Street II pen kit.
Not for the faint of heart!
This kit, like most of these kits, exhibits poor fit and easy breakage. I found the only way to get the stem in was to break it at the bottom. Fortunately, the break does not show. The leaves are very difficult to install without breaking them into multiple pieces.With enough patience and a deft touch this can be completed and turned into a wonderful pen.
No, I would not recommend this to a friend
1 - 6
Back to top
©2013 by Woodcraft Supply LLC