Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Order now for current pricing.
Item will ship after 08/22/2014.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 3
Back to top
Perfect for a specific application
Whiteside Corner Chisel for Hinges
This product is perfect for a specific application- cleaning out the corners of routed hinge mortises. The tool seats perfectly in the corner, one tap with a hammer and the mortise is square. It works well even in hickory and hard maple. We've had ours for months in a production environment and it is still holding up well. Highly recommended if you make entry doors.
Yes, I would recommend this to a friend
Great idea, poor design
Overall, I suppose it's called a "hinge chisel" for a reason. If I had tried it on a pine door for a 1/8" deep cut, I might be happy with the chisel. Great idea but a tough design to handle .
It's very difficult to keep steady for any type of corner cut. The back side of the corner chisel has been beveled so much that the chisel has a hard time sitting level. It has a tendency to rock back and forth. If the back side of the chisel was not beveled off, it would allow more of the chisel's base to rest on the project.
It might work well for small hinge clean out but for any other corner cut I would not recommend it. Specifically, rabbet cuts for panels or glass. The corner radius and depth left by the rabbeting bit is too large for this chisel.
No, I would not recommend this to a friend
Fine product1 Does what it says.
San Jose, CA
I use the Whiteside cornor chisel for squaring up the corners of routed tile inlays. Does a super job!
1 - 3
Back to top
©2014 by Woodcraft Supply LLC