Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 6
Back to top
Good product for bowl sanding.
King Arthur Inflatable Round Sander
I've been using this inflatable sander for a couple years now. I find it works well on small bowls turned on my midi lathe. It takes a little practice to get the washers lined up for assembly, but I've not had much trouble. It has never deflated unintentionally (unless overinflated). In use, care needs to be taken to avoid excessive heat, but using the correct grit usually minimizes the sanding time and temperature. I haven't tried any other sanding systems because this one has always worked for me. I'm going to check into the buffing system as well.
Yes, I would recommend this to a friend
Sandpaper comes off
It would be great if the ball would stay inflated. The paper keeps sliding off, even when I give it two pumps. Perhaps because of this, the sandpaper comes apart in the operation. Overprices, so not sure I would recommend.
Concept is great but difficult to expand with sandpaper on.
Gets to the bottom of the Spoon
The round sander is ideal for getting into the bowl of the spoon and is perfect for sanding out those home made bowls. Gets into the round edges and produces a perfect finish with the sanding bonnets. The round sanding head does not have a deflating vent which causes a bit more time when reinflating the bulb.
I purchased this when a fellow shopper in the store advised me it was a good way to sand concave radii. I do understand what the reviewer above may be going through, as the rubber could use a better lip to hold the metal shank centered. If centered it's about half a pump to hold the sanding cup.
I have difficulty sealing the dome, even though it gives visual appearance of being properly centered and seated. There is no apparent damage to the rubber, and I have cleaned it, so I am not sure just why it is so difficult to inflate it enough to hold the sanding cap on.
Like so many others, I seem to be on an endless search for a good solution to lathe sanding problems, Sigh.
No, I would not recommend this to a friend
1 - 6
Back to top
©2014 by Woodcraft Supply LLC