Self-Squaring Frame Clamp

Comments about Self-Squaring Frame Clamp :

I am new at making frames, I started so I can deal with scrap wood, never got it square as I like till I broke down and bought this set, not I am planning on getting several more.

Comments about Self-Squaring Frame Clamp :

The clamp is easy to assemble and even easier to use. It glues perfectly tight mitered corners. Well worth the money.

Comments about Self-Squaring Frame Clamp :

simple and easy to use--made 4 frames in less than an hour-- way better than the band clamps I was using

Comments about Self-Squaring Frame Clamp :

The wing nut it too hard to tighten enough to get enough pressure. I replaced it with a hex nut and tighten it with a ratchet wrench that can slip over the long bolt. I've tried other clamp products and this one is the best. I bought four of them so I don't have to wait for glue set time when I'm making multiple frames.

Comments about Self-Squaring Frame Clamp :

well constructed and easy to use.

Comments about Self-Squaring Frame Clamp :

For gluing up frames it works great. Took a little time to figure out how to set it up, but after that it was a breeze. Tip: Get the frame set in the jig. Tighten it up. get it square (corner to corner). Then release the wing nut just enough to get one side of the frome out. Glue both sides of that piece. Put it back in the jig. Then do the same thing on the opposite side of the jig. Tighten up jig. Check for being square. Wait for the glue to dry. It is that simple.