Close
Sign Up Today and Get a Special 10% Off Coupon

WoodRiver Round Over Router Bit 1/2"SH 1/8"R

Item #147247
$20.99
Qty.   or Add to Wish List

 
2.5

(3 reviews)

Read Reviews | Write a Review


Product Information:

The anti-kickback design of these industrial quality carbide router bits limits stock feed rate for safer router operations. Solid steel bodies are precision machined to carefully controlled tolerances. A final CNC machine 600 grit wet grind on the K-20 German carbide produces a clean, extremely sharp, and durable cutting edge. Bit bodies are coated to help prevent resin build up and make resin removal easier. High quality Japanese bearings are used on bits fitted with guide bearings. This bit is carbide tipped.


  • For uniformly rounded edges
  • Lowering the depth setting will produce a rounded corner with a decorative fillet
  • Changing the guide bearing to the 3/8" bearing converts round over bits to beading bits
  • California Residents: Click here for Proposition 65 information.

     
     

    REVIEW SNAPSHOT®

    by PowerReviews
     
    2.7

    (based on 3 reviews)

    33%

    of respondents would recommend this to a friend.

    Pros

    • Easy to use (2)

    Cons

    Best Uses

    • In the workshop (2)
    • Reviewer Profile:
    • Avid do-it-yourselfer (2)

    Displaying reviews 1 - 3

    Back to top

    |

     
    5.0

    Great ! Cuts like a bit should

    By  Edd

    from NW Indiana

    About Me Avid Do-It-Yourselfer

    Pros

    • Easy To Use

    Cons

    Best Uses

    • In The Workshop

    Comments about WoodRiver Round Over Router Bit 1/2"SH 1/8"R :

    Used it on oak finish was great !

     
    1.0

    poorly made

    By  helen

    from san francisco, ca

    About Me Avid Do-It-Yourselfer

    Pros

    Cons

    • Hard To Use

    Best Uses

    Comments about WoodRiver Round Over Router Bit 1/2"SH 1/8"R :

    For [$] I expected a pretty good bit. This bit is absolutely horrible, the bearing is slightly undersized by a hair so the bit always leaves a tiny groove on the routed piece. When I was doing production work, I had to spend an extra few hours to sand the groove out. I ended up putting a slight piece of tape around the bearing so the groove wasn't so deep. These bits are horrible, stick with Whiteside or CMT. I wish I could ask for a refund, but this bit is just going into the garbage.

     
    2.0

    wood river round over bit

    By  Guido

    from Medford, OR

    About Me Casual Do-It-Yourselfer

    Pros

    • Easy To Use

    Cons

    Best Uses

    • In The Workshop

    Comments about WoodRiver Round Over Router Bit 1/2"SH 1/8"R :

    cutter seems ok but the shank is far too short for bigger routers

    Displaying reviews 1 - 3

    Back to top

    |