Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 7
Back to top
Post, 1" Diameter, 3.5" Long
Based on previous reviews, I was almost afraid to buy it, but needed a larger post for my new lather. Maybe there was a previous quality control problem, but mine is a couple of thousands under one inch and it works great.
Yes, I would recommend this to a friend
It's An Inch Now
Ordered this for a harbor freight 34706 lathe, which has a 25mm post dia. With the previous comments about the posts being undersized, I expected it to fit w/o modification. Turns out the posts are an inch! ~ 1.002 according to my calipers - I figure the paint is 0.002". Light reaming of the hole had the post fitting very well. So you can by the right height, the threads on the posts are 5/8" of the length. I don't have any issue with the rest coming loose, but I don't turn way out of balance stock.
Solid and accurate
Use some locktight or maybe a lock washer to keep the rest from loosening on the post.
Baton Rouge, LA
It would be better if the post's diameter were increased just a bit. It fits too loose, so it's hard to get a good solid anchoring platform for your tools.
Diameter is too small
The diameter of this post is approximately 0.035 inches too small which means it doesn't sit properly in the 1" mount of the banjo. As others have mentioned this makes the tool rest wobble if it's not really tightened down. I'm having a post custom made so I can still use the tool rest I bought.
No, I would not recommend this to a friend
Bad product, don't buy
The post is under sized and does not fit well causing the tool rest to wobble when you move your tool from side to side. When turning wood the tool rest should be DEAD STABLE!!!
Not the best
Well made, but seems a little loose in the 1" banjo.
It's just a hair smaller than the 1" spec.
1 - 7
Back to top
©2015 by Woodcraft Supply LLC