Save $35 on WoodRiver® Adjustable Mobile Base
Maximise your shop space by putting tools on wheels.
Now Only $49.99
RIKON 17" VS Drill Press
Every shop needs a quality drill press. It's a must.
Save $100 Today!
Save $40 on this Bench Mortiser
Chosen as a "Best Value" by Fine Woodworking
Buy Now $249.99
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 4
Back to top
Bought for my Delta Lathe
Grand Prairie, Texas
Post, 1" Diameter, 5" Long
The post fit my lathe perfect but I had to cut it off a little because it was too long, it made the tool rest way above the center on my part.
Yes, I would recommend this to a friend
Ordered what was in the picture but only got half of it. Didn´t realise i had to order seperately the top of the tool rest.
I bought this tool rest post and the 3.5". The 3.5" post is way short for my Delta full sized lathe but that was my fault when I measured the old rest. This post is a little undersized but not so the I cannot use it. It is a little long for my Delta, you cannot get it to go down enough for some applications. I will need to grind about 1/4 to 3/8 off of the bottom. The round rest that goes on top are not a real good Idea. See the note I left about them. These posts are OK but need to be reworked a little.
not everything it could be...
this post is advertised as 1' in diameter... more accurately it is .975" in diameter... this may seem a small amount of slop, but it makes a difference... i bought this for my powermatic 3520b lathe and did not take into account i needed to add about an inch to the post height to compensate for the shorter rest height... my error and i'll take care of that...
it would be nice if woodcraft had the foresight to indicate whether or not a given rest/post combination would or would not work for various lathes...
i'll be back...
1 - 4
Back to top
©2015 by Woodcraft Supply LLC