Close
Sign Up Today and Get a Special 10% Off Coupon

Jointer Blade Hone, Aluminum Oxide

Item #09T14
$15.99
Qty.   or Add to Wish List

 
2.5

(3 reviews)

Read Reviews | Write a Review


Product Information:

Keep your jointer and planer knives razor sharp and knick-free without ever removing them from the cutterhead! Simply unplug your machine, lock the cutterhead in position, align the 4" hone on the knife edge and with a few quick strokes you're back to cutting. Aluminum oxide hone has 180 and 400 grit surfaces and should be lubricated with oil prior to use. Not recommended for portable planers with disposable knives. Diamond hone also available (Woodcraft #123679).


  • Aluminum oxide jointer blade hone

  • 180- and 400-grit surfaces should be lubricated with oil prior to use

  • Keep jointer and planer knives sharp without removing them from cutterhead

  • Diamond hone also available (Woodcraft #123679)

  • Not recommended for portable planers with disposable knives

  • California Residents: Click here for Proposition 65 information.

     
     

    REVIEW SNAPSHOT®

    by PowerReviews
     
    2.3

    (based on 3 reviews)

    33%

    of respondents would recommend this to a friend.

    Displaying reviews 1 - 3

    Back to top

    |

     
    5.0

    I was dead wrong and stupid!!!

    By  Brad

    from Lawrence, Kansas

    About Me

    Pros

    Cons

    Best Uses

    Comments about Jointer Blade Hone, Aluminum Oxide :

    I gave an unfair and totally incorrect appraisal of this tool last Spring. Not paying attention to the name of the device, I tried to sharpen my planer blades, enter stupidity. The name of the tool indicates it is for a jointer, not a planer, DUH!!! A little while ago, I was computer searching for a way to sharpen jointer blades and the WC ad for this tool appeared. I swiftly kicked myself in the rear section and got out the sharpener. Using the photo showing how it is positioned on the blades, I sharpened the JOINTER blades to perfection and finally got rid of snipe. My apologies to WC and my Lenexa store.

     
    1.0

    Save your money

    By  Bradkansas

    from Lawrence, Kansas

    About Me

    Pros

    • None

    Cons

    • Ineffective

    Best Uses

    Comments about Jointer Blade Hone, Aluminum Oxide :

    I bought this thing today (4/15/13) at the Kansas City store for my Delta 12 1/2" planer purchased at WC about ten years ago. It does not fit my blade set-up and there is no information how to use the "tool". I tried the best I could to make it work and found there is no way to steady the stones according to the angles of the chippers and knives. Further, it is not possible to make contact with the ends of the knives because the housing of the machine blocks it. You will not find anything on the internet about how to use it. My regret is I tried to get it to work and rendered it not returnable but I'll try. WC will send your knives for sharpening at a cost far less than any sharpening device. WC should take the thing off the market or at least post an advisory regarding it's uselesness on a Delta 12 1/2". Bradkansas

     
    1.0

    mostly junk and useless

    By  Ralph

    from North Florida

    About Me Midrange Shopper

    Pros

    • none

    Cons

    • Waste of money

    Best Uses

    • Garbage

    Comments about Jointer Blade Hone, Aluminum Oxide :

    Product does not work. Directions are vaugue. A waste of money. Not worth keeping.

    Displaying reviews 1 - 3

    Back to top

    |