Shop Now & Save $200 on RIKON Deluxe Bandsaw
This 14" deluxe beauty is perfect for any shop.
Buy Now for $799.99
Cool Retro Green Shop Stool $49.99
Take a load off with this chrome retro stool.
Shop & Save $20
Save $40 on RIKON Slow-Speed Grinder
Keep old tools sharp without edge destroying heat.
Now Only $99.99
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 10
Back to top
Quick and easy
Whiteside 5 Piece Brass Set-up Gauges, 4"
I use these when having to make multiple routing and shaping setups
Yes, I would recommend this to a friend
great product for the money
Product is great for router and saw set ups ,saves a lot of time and is dead on
A simple tool that comes in very handy.
Meadow Lakes, Alaska
So far I've used these sizing bars for router and tablesaw setups and checking dado depths.
They 're just what needed
Bowling Green, KY
Used for set where I need an accurate measurement
More Than I Expected
I bought the gages primarily for use in setting up a dado jig; however, I have already fround a couple of other uses. I think there will be many more.
Good is good
These set up bars are great they ensure accuracy, speed up set ups they are great to have and they are 4" long great for router set ups when using large router bits and the opening is big they won't fall thru the opening and brass will not damage your blades or bits in case of accidental contact. Great price.
New Braunfels, TX
I was suprised to find that the bars profile is square. Others that I have used were dimensioned for the bar size in only one direction. (The smaller bars were flat.) You don't have to worry about laying the bars down wrong. But, these square profile bars are a bit harder to stack and keep stacked.
There are no dimensions on the bars. And, for the smaller bars, there isn't enough room to write the dimension on the bar either.
No, I would not recommend this to a friend
Vary Handy Accessory
Very nice idea, a great time saver when you get used to using them instead of trying to measure with a tape.
I use these pre-measured blocks for consistant & repeatable known height & depth set up's on the Table Saw, Router & for gauging Dado cut width's after shimming the blade stack
Five 4" long bars
These bars make setup real easy.
Whiteside 5 piece Brass set-up gauges.
Even though the size is obvious I would prefere that the size is marked on each gauge.
1 - 10
Back to top
©2014 by Woodcraft Supply LLC