Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 1
Back to top
Palo Alto, CA
Kreg Universal Bench 29-Inch 4-Piece Leg Set, Kreg #KBS1000
I'm aware that "guys" aren't expected to read assembly instructions. However, here are two helpful suggestions based on my recent assembly of a Kreg workbench, combining Kreg legs, Kreg rails and my own top. 1) The bolts and self-locking nuts that connect that legs to the rails are listed as 5/16 (no need to verify since they're shipped together as a kit). However, the wrench size needed to tighten these nuts is 12mm, not the inches size listed in the manual. 2) The rails are u-shaped channels. The holes to mount the top are in the "legs" parts of the u-channel. The U-channels are symmetrical, with holes at identical locations on both of the channel's legs. To avoid the necessity of holding the screwdriver at an angle when tightening the screws, I inserted a long-handled driver bit through the hole on the opposite leg of the channel to contact the screw head straight-on. The Kreg-supplied screws are square-drive (excellent choice). However, extra-length, square-drive bits aren't very common. Then I recalled, the Kreg pocket jig system includes a longer-length drive bit. It really made attaching the top much easier. Now to my point: Did the Kreg assembly instructions for the bench legs/rails suggest using the Kreg drive bit in the Kreg jig system? The long form of the answer is "no".
Yes, I would recommend this to a friend
1 - 1
Back to top
©2014 by Woodcraft Supply LLC