Save $50 on Freeman Combo Kit
Includes a 2" Brad Nailer and 1" Micro Pinner.
Buy Now $69.99
WoodRiver® Universal Mobile Base Kit
Save $13 and go mobile with this Mobile Base Hardware Kit.
Now Only $49.99
Pizza Time! Save $3 On This Pizza Kit
This heavy-duty Pizza Cutter features a 2½" stainless steel blade.
Make Yours! $9.99
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 5
Back to top
Seam Ripper Kit Gold
clean tube and remove burrs with fine chain saw file works wonders.
and put a little vaseline on O ring after installation on piece.
Yes, I would recommend this to a friend
No Replacement Blades available
I like the weight and feel of this item. I called customer service to see if I could order a replacememt blade. Its labeled as Part A in the instructions. This is even threaded and would make replacing a blade easy. But no replacement blades are availible.
No, I would not recommend this to a friend
E. Aurora NY
I like these kits. I had a problem too with the o-ring on the first one I made because I had glue leak into the tube. I now pack the tube with modeling clay to keep it clean. I wouldn't recommend sanding the inside of the tube. The rougher surface stops the o-rings from working smooth. Debur, chamfer and polishing the inside is ok to do. I find if you just wet the o-ring slightly they slide in nice. It would be nice if they put a couple of extra o-rings in the package. My wife is a quilter and uses it a lot.
Seam Ripper assembly fixes
Jeff In Seattle
The O-rings when installed on the blade holder make it to large to fit inside the brass tube.
I have found that by turning the blade holder on my lathe in a chuck fitted with pin jaws I can sand the grove and reduce the diameter enough that the O-rings will fit inside the brass tubes. It take a few attempts to get the fit right.
I also chamfer the brass tube slightly.
I've also noticed while test fitting the blade holder (with the O-rings installed) that twisting the blade holder while pushing it in the tube works the best. Often no further modification is required.
Wet Foot Wes
Received my order for 5 kits on 1/26/12 and upon inspection was impressed. I ordered these after reading too many negative reviews at other merchants sites and felt that the quality here would satisfy my needs. The kit is very well made, BUT the interior diameter of the brass tube is too small when the "O" rings are installed, and too large without them.
De-burr the tube as instructed and with a split mandrel that fits sloppily inside the tube, cut a piece of 220 grit sand paper to size, and enlarge the interior, then with length of 1/4" dowel chucked in your lathe charge it with emory compound and polish the interior until you achieve a good fit.
It may take several attempts - and it really slows down production.
Without opening the inside diameter the fit is so tight as to either ruin the "O" rings, or be way too hard for the recipient to use.
Short of a custom reamer, I have not found a better way to enlarge the tube. Hopefully one of you will and so advise.
I gave it a 4 star rating because it does have potential and would recommend it with the above understanding.
1 - 5
Back to top
©2014 by Woodcraft Supply LLC