Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 4
Back to top
YOU MIGHT WANT TO WATCH THIS
General 14" Bench Top Drill Press
So far I like this Drill Press. I drilled four holes in four 1/4 inch plates using just a clamp and the table it comes with. Now keep in mind I had cobalt bits while doing this. My first thing to watch for, the table is ribbed underneath, so finding a clamping area is tricky but possible. I know, get a press vice. Well, money being what it is......The other thing to watch for is that the depth gauge guide on the left as you face the table, the threaded rings are hard to tighten in place, so they vibrate down the shaft as you work. Plate three, hole three. Started through, got half way, then the bit just stopped grinding. I thought the bit had gone dull. Then I saw it, the rings had both spun down to where the drill arm wouldn't go any further. I wasn't concerned about the depth gauge, so it didn't even dawn on me to look. I almost bent the metal stop flap because I was attempting to put a wee bit more pressure on the bit head to get it to grab. You might want to remove those rings if using the gauge is not part of your job.
Yes, I would recommend this to a friend
Decent machine for the price.
Not a bad press for the price. The size was right for me because my garage shop is not too big and this has a decent footprint. I haven't had any problems at all with it. I also found that it wasn't to difficult to assemble. I would recommend this press if you are just doing normal drilling and don't want to spend to much on a fancy machine.
poor castings any you better be tall
Be sure to read the assembly instructions carefully. They could be better and more complete. Installing the rack and table arm to the tower has to be done simultaniously.
Be sure to install the safety shield before you install the chuck. I broke mine.
Casting quality was poor on the table. The shaft had large hole in the side and there were numerous bug holes in the machined table surface. I expected better. I would have returned it but the hole, the size of a dime, was not in a location that would see a lot of stress loading. Poor quality control based upon their reputation. The laser center is of questionable usability as it has to be realigned with every change in table height.
I am short. This tool is very tall. If you are 6' or over, you should have no problem using it setting on your bench. I'll need to stand on a riser to use it. Not a good thing to do in any shop. Later, I will build a drop table to lower it. I can only recommend this tool with the above reservations. Might have made another choice had I know this.
Instructions could use some help.
A few things with the directions. If your going to use the chuck guard you need to put it on before you attach the chuck to the drill.
When putting it together if you have issues getting the table arm onto the pole you might need to put the arm and the gear path together before you put it onto the pole.
1 - 4
Back to top
©2014 by Woodcraft Supply LLC