Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 6
Back to top
On consideration, not bad
4140/250 Straight Back Saw
I bought this saw over a year ago, and I've been using it occasionaly to make (very) rough cuts in small pieces. I'd never really been happy with it, but it was the best tool I had for cuts that small.
Finally, yesterday, I sat down to try to figure out what was wrong with it once and for all. After a lot of consideration, while I was checking to make sure the blade wasn't kinked, I realized the kerf it was cutting was something like 3 times the width of the blade. The set was so much that it was allowing a full blade-width on each side of the plate. Right... that's easy to fix.
I decided to go with the hammer method, just because I had a hammer and anvil handy and my sharpening stones were in the other room... a very light tap with a light hammer on each set of teeth, backed with an anvil, and the set is substantially less: I'd say around 1.25 times the thickness of the plate.
The blade still needs to be sharpened (that happens when you use a saw for over a year), but it cuts far faster, and with a better finish, than it used ot.
So the saw is quite serviceable, but you're not buying a ready-to-use tool. You'll likely need to remove some of the set, and it may also need sharpening; be aware that sharpening teeth this small is kind of a nuisance. I've done larger saws, but I don't even have the right file to work on teeth thsi small.
Yes, I would recommend this to a friend
Learn To Sharpen The Saw
Salt Lake City, UT
At your local library, take out a copy of and watch Frank Klausz's DVD called "Hand Tools: Tuning and Using Chisels, Planes, and Saws." In this video Klausz shows in detail how to set and sharpen a dovetail saw with the Deer Brand Logo on the blade. In a short time on the video Klausz makes the saw sing! And he shows how not too difficult it is to learn to sharpen the saw yourself.
Don't judge a book by its cover
Doesn't cut well. Also too thick.
No, I would not recommend this to a friend
Great saw, after a little tuning up
I use a lot of these due to low price and decent quality. Kerf is bit wide for easy control and finish out of the box, but that can be easily remedied by removing most of the set with a white Arkansas or equivalent slip. That reduces the 0.031" kerf to around 0.023", which cuts straighter and a LOT smoother, with greater speed and less effort. Further work with the slip reduces the kerf to 0.021", perfect for cutting guitar fret slots -- in fact, this saw seems to be the only one I can find suitable for that job, even from luthier's suppliers.
The cheap comes out expensive
MG - Brazil
It isn't expensive, but does not pay. OK for services that do not require a perfect finish.
good for the price
Santa Fe, New Mexico
This saw was good for the price but I definitely plan on an upgrade in the future.
1 - 6
Back to top
©2014 by Woodcraft Supply LLC