Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 3
Back to top
Fast and accurate
Laurey Perfect Mount Template for Drawers
I have built many drawers. I have created many templates for the job at hand, and this is the fastest that I have used. On the surface, this is very simple. First, the center point (left to right) is marked, so, if you mark the center point (left to right) on the drawer, it is trivial to center your drawer handles and knobs.
The template provides drilling points for the center (left to right) and also points for screw holes that are 3", 3.5", and 4" apart. Each of these "widths" provide hole points that are 1", 1.25", 1.5", 2.5", 3", 3.5", 4.5", and 5" from the top. Obviously, you can flip it around and you have holes that distance from the bottom. So, when I had a drawer that was 6.75" tall, I set the template and used the holes 3" from the top.
I use this by setting the top ridge along the top (or bottom) of the drawer and then I use an awl to mark the locations that I desire to drill. I then use a brad point bit to drill my hole in the drawer front. If I desire an "unsupported" distance, i can place a spacer block between the drawer top and the top lip of the guide.
The guide also has two extra sets of holes. One is marked 50mm x 96mm, and the other is labeled 100mm x 96mm. This is for handles that have "holes" 96mm apart. The first set is 50mm from the top, and the other is 100mm from the top.
You can as easily use this to place handles that are not 'centered' by setting your "center line" at an appropriate location; for example, if you want to place drawer pulls3" from the left and write, just mark the spot then use this guide.
Yes, I would recommend this to a friend
flat rock michigan
this product is suited for basic cabinet hardware installations and does the job , however after i purchased this product as well as the cabinet door template for approx. [$],i found both products at a [...] for about $3 each.
Made the job easy
This product made a potentially long job a snap!
1 - 3
Back to top
©2014 by Woodcraft Supply LLC