Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 4
Back to top
Special note for Shopsmith Users
Kansas City, Missouri
Nova 5/8" Plain Insert
Whereas this adapter (Teknatool PN 'IFNS') works ok with the Shopsmith Mark V, any potential buyer with a Shopsmith should be aware that there is a newer and better adapter from Teknatool with Teknatool PN 'ISNS'. The 'ISNS' adapter has a deeper shoulder and uses a bigger set screw which is angled to match the taper on the Shopsmith output shaft. These features are particularily important with the PowerPro equipped Mark Vs and Mark VII.
To repeat, the 'IFNS' adapter works fine with the Shopsmith (I had one for several years with my G3 chuck). But the 'ISNS' adapter is just a bit better.
Yes, I would recommend this to a friend
Images shared by
Teknatool Nova insert/adapter - Type F and Type S
Picture of Product
Always Great Products
Sioux Falls, SD
All products that I have purchased from Woodcraft over the Internet and at the Minneapolis store were TOP quality products. All of my transactions with Woodcraft have been good transactions. I have no complaints, only strong recommendations.
Exactly what I needed
The adapter was required to mount my new chuck on my Total Shop. It was backordered but arrived when estimated. It is exactly what is needed.
Just what I needed to mount the chuck
Perfectly adapted my nova chuck to the Legacy REVO ornamental mill.
1 - 4
Back to top
©2014 by Woodcraft Supply LLC