Save $40 on RIKON Slow-Speed Grinder
Keep your tools sharp and safe without edge destroying heat.
Buy Today & Save
$25 Off HTC Tool Table
You'll find hundreds of uses for this table in your shop.
Now Only $39.99
Six-Shelf Wood Rack Now $39.99
Safely and properly store wood with this customer favorite.
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 3
Back to top
Perfect for the Job
Lid Support, Left, 45-55 Ip Lids
I needed these lid supports for four segmental lids of a long built-in window seat. When the contractor finished the seat, the lids not only slammed down hard, but also the two end lids didn't stay open (where they contacted the window side trim). I knew I needed something to protect my 6-year-old's fingers and head. These lid supports were the perfect solution!
I used two supports per lid (right and left). I calculated the required moment in advance and bought the 45-55 inch-pound supports for an appropriate 90-110 inch-pounds of support per lid. The lids now stay open at any opening angle, close gently, and stay closed when closed.
Also, I had to install the supports upsidedown because the hinges on my window seat lids are on the top rather than on the back as it would usually be for a free-standing chest. When I bought the supports, I wasn't sure if I could flip them upsidedown for my application or not, but in case anyone else has the same question, I can confirm that the supports work inverted as well for hinge-on-top applications.
Basically, when the hinge is open to 90 degrees, you will have two surfaces that are parallel, but separated by the 3/4" thickness of the back or top of the piece you're attaching to. The body of the lid support should be aligned parallel to both surfaces and oriented so that the end with the longer "knee" spans the 3/4" gap to reach the farther surface. In my inverted scenario, I attached the top first (nearest screw centered 1-1/16" from the edge) and then the bottom with the lid open. Just like the diagram in the instructions, but flipped upsidedown.
Yes, I would recommend this to a friend
something not right
tried following the directions to the letter but decided the toy box lid type was not the same as the one shown in directions even though we tried to adjust according after many attempts had to remove the support as it would not close the lid fully.. May be it would work on a different style, do not know... just wasn't any good for us
No, I would not recommend this to a friend
Support for chests with 3/4" backs
Ed the woodworker
Redwood City, CA
Great product, but the Woodcraft catalog neglected to say that it was designed for use only for chests with a 3/4" back. A call to the manufacturer confirmed that, and they sent me (for free) units designed for the 1 1/4" back on my chest. Unfortunately, I had to fill the holes created when installing the original units.
1 - 3
Back to top
©2014 by Woodcraft Supply LLC