Shop Now & Save $200 on RIKON Deluxe Bandsaw
This 14" deluxe beauty is perfect for any shop.
Buy Now for $799.99
Cool Retro Green Shop Stool $49.99
Take a load off with this chrome retro stool.
Shop & Save $20
Save $40 on RIKON Slow-Speed Grinder
Keep old tools sharp without edge destroying heat.
Now Only $99.99
Look up product instructions, videos and articles about your favorite tools using our Learning Center.
Join us on your favorite social network! Share your projects and learn from other woodworkers.
Please Note: This item can only be shipped ground to the 48 contiguous states. Some
items cannot be shipped via air due to being flammable, magnetic, contains batteries,
hazardous fumes or where contents are under pressure. Please use a physical address
not a PO Box during checkout.
of respondents would recommend this to a friend.
1 - 10
Back to top
Ok but a bit lacking
50-Inch BORA Clamp Edge Tool Guide
These clamps are a great idea but poorly executed.
They must be used with a precision square as the bevel cut paw will go off 90 pretty easily.
They also flex along wider surfaces which can lead to inaccuracy.
Lastly, after a little while, the metal parts which catch the tension rod inside will dig into said bar causing the adjustable paw to lock in place and become extremely difficult to use. Be warned.
To the folks at Bora, great idea, just please use harder steel on that rod!
Yes, I would recommend this to a friend
Don't waste your money!!
New Port Richey, Fla.
Not for woodworkers! Cutting cherry ply very $$$ did a poor job.....
No, I would not recommend this to a friend
Its OK . . . but has limitations
Easy to use and quick, accurate setup. A problem arises, however, when you use it to establish a straight edge that uses the full length of the device. The device isn't quite stiff enough to prevent flexing when clamping a 48" board. It flexes up to 1/16 inch or so under only moderate pressure (for example, when using a router to cut a slot in plywood). You need to brace the device in the center to prevent this movement. It's a hassle and detracts from its otherwise easy use.
Good, handy tool
Good deal. Save me a lot of time for crosscuts up to 4' wide. Need a extra effort during clamping to prevent slipping (sliding), but over all very useful tool, recommended!
Just what I needed!
I needed to crosscut 20 plus sheets of paneling.
I have a table saw but I hate to man handle that many sheets so I decided to set up an 8' table and use my circular saw and needed to make a repeating setup. I could have easily gotten by with C clamps and my straight edge, but this made the job so much quicker. The table saw type of quick clamp and release is great.
GREAT FOR RIPPING PLYWOOD
this is an amazing way to use along with my power tools, keep em coming
Easy and quick to use Light weight and accurate
This is the perfect tool for making long straight cuts on sheets of plywood. It is lite in weight and easy to set up. The most accurate way i have found.
Williamson County, Texas
I like the length.
1 - 10
Back to top
©2014 by Woodcraft Supply LLC